Buy rugged Tablet PC:How to correctly buy a  rugged Tablet PC?

Buy rugged Tablet PC :One, the edge of the shell,the toughness of the device.

buy rugged Tablet PC,In addition to some low-cost products, many products of the shell grinding tools are used without screw design. This kind of shell in the maintenance process, the need to use tools to pry the joints. So after the refurbished products may appear some obvious traces. In addition, even if not after disassemble repair, but a lot of Core i5 three anti-Tablet PC are used plastic material. This shell technology is not very mature, so the use of the product more or less there will be some “Alice” situation. This is due to the heat characteristics of the Andrews system.

In addition, Ereli Young Xiaobian to remind you that some scratches will appear on the edge of the product Alice, but does not mean that the product is a refurbished product. Because the products are mass production line, so in the bulk display process will use some tools to carry out the product and fixed. And some scratches are in the process of placing and fixed. So, when we compare pry marks and scratches to pay attention to, with two identical machines for comparison, if more than two machines have the same scratches, it shows that the machine’s scratches from the production, and vice versa Refurbished.

Second, the screen often by location

Some tablet PCs, especially soft-screen tablets. In the renovation process, although the workers clean up some of the traces of renovation, but some traces can be resolved through the trial or out. For example, the screen often touch the location. We can be seen in a number of ways to find. For example, if there is a regular point in the middle of the screen, then perhaps we can not distinguish from the front view, but if the side of the Tablet PC to reach 30 degrees or even larger angle on the light, then this point will The other parts of the product screen are significantly different.

Third, the interface part, on buy rugged Tablet PC

Industry use rugged tough tablet pc

Interface part we usually mainly look at the application of more USB interface and headset interface. While the TF expansion interface and HDMI interface because the application frequency is less and not too much care. As the user needs to define more interfaces, including fingerprint identification, NFC, RFD and other functions.

First we have to look at the edge of the headset and USB interface. These two kinds of interface plug frequency is very high, so the edge of the interface is easy to leave the traces of wear. Especially the USB interface, because the interface edges and corners more clearly, so the refurbished products will have obvious traces of processing. Moreover, these two kinds of interface internal metal part we can also use eyes to observe. Because of these products on the refurbished, these metal parts will be due to wear and tear of the surface of the oxidation of the weak, slightly discoloration is still very easy to observe.buy one rugged Tablet PC is so important.

Four, concave screen and the Touch Panel toughness.

Today, most of the Tablet PC screen is divided into two kinds of concave or overall coverage. If it is concave screen, then we should carefully observe the time of the product screen, the upper right corner of the screen and the lower left corner of the product screen and other locations. Because, these locations are Andrews screen touch buttons on the main corresponding position, if it is used products, then even if the use of very careful, how refurbished carefully, then the product will appear more or less Other edge positions are different.

Abe Long introduced four points how to correctly buy the Tablet PC method, hoping to read the friends of this article to bring more help, at the same time, would like to continue to understand Ai Rui Long product friends, welcome to consult IRL customer service for further understanding.

For More info you can press here to get more .

Also IRL(Ai Rui Long,its chinese name in pronouncation) is a Manufacturing group ,with its own Molding unit,its own SMT line, PCBA Design House ,and will give you a total ODM solution for your product development .